aws storagegateway attach-volume

Connects a volume to an iSCSI connection and then attaches the volume to the specified gateway. Detaching and attaching a volume enables you to recover your data from one gateway to a different gateway without creating a snapshot. It also makes it easier to move your volumes from an on-premises gateway to a gateway hosted on an Amazon EC2 instance


--gateway-arn <string>The Amazon Resource Name (ARN) of the gateway that you want to attach the volume to
--target-name <string>The name of the iSCSI target used by an initiator to connect to a volume and used as a suffix for the target ARN. For example, specifying TargetName as myvolume results in the target ARN of arn:aws:storagegateway:us-east-2:111122223333:gateway/sgw-12A3456B/target/ The target name must be unique across all volumes on a gateway. If you don't specify a value, Storage Gateway uses the value that was previously used for this volume as the new target name
--volume-arn <string>The Amazon Resource Name (ARN) of the volume to attach to the specified gateway
--network-interface-id <string>The network interface of the gateway on which to expose the iSCSI target. Only IPv4 addresses are accepted. Use DescribeGatewayInformation to get a list of the network interfaces available on a gateway. Valid Values: A valid IP address
--disk-id <string>The unique device ID or other distinguishing data that identifies the local disk used to create the volume. This value is only required when you are attaching a stored volume
--cli-input-json <string>Performs service operation based on the JSON string provided. The JSON string follows the format provided by ``--generate-cli-skeleton``. If other arguments are provided on the command line, the CLI values will override the JSON-provided values. It is not possible to pass arbitrary binary values using a JSON-provided value as the string will be taken literally
--generate-cli-skeleton <string>Prints a JSON skeleton to standard output without sending an API request. If provided with no value or the value ``input``, prints a sample input JSON that can be used as an argument for ``--cli-input-json``. If provided with the value ``output``, it validates the command inputs and returns a sample output JSON for that command