aws elbv2 register-targets

Registers the specified targets with the specified target group. If the target is an EC2 instance, it must be in the running state when you register it. By default, the load balancer routes requests to registered targets using the protocol and port for the target group. Alternatively, you can override the port for a target when you register it. You can register each EC2 instance or IP address with the same target group multiple times using different ports. With a Network Load Balancer, you cannot register instances by instance ID if they have the following instance types: C1, CC1, CC2, CG1, CG2, CR1, CS1, G1, G2, HI1, HS1, M1, M2, M3, and T1. You can register instances of these types by IP address


--target-group-arn <string>The Amazon Resource Name (ARN) of the target group
--targets <list>The targets
--cli-input-json <string>Performs service operation based on the JSON string provided. The JSON string follows the format provided by ``--generate-cli-skeleton``. If other arguments are provided on the command line, the CLI values will override the JSON-provided values. It is not possible to pass arbitrary binary values using a JSON-provided value as the string will be taken literally
--generate-cli-skeleton <string>Prints a JSON skeleton to standard output without sending an API request. If provided with no value or the value ``input``, prints a sample input JSON that can be used as an argument for ``--cli-input-json``. If provided with the value ``output``, it validates the command inputs and returns a sample output JSON for that command